Select Page

ASME Basic Calibration Blocks

ASME Basic Calibration Blocks (Fig. T-542.2.1)

ASME Basic Calibration Block, Sec V Articles 4, Fig. T-434.2.1, Article 5 Fig. T-543.2.1. Article 5 was revised in its entirety in 2002.

sed for Angle Beam DAC and TCG Calibration.

ASME Basic Calibration Block | Advantage NDT Supplies Ltd.

 

Standard Materials:

  • Carbon Steel A36/1018
  • Aluminum 7075
  • Stainless Steel 304
  • Titanium 6/4
  • Inconel 600
  • Monel 400

Contains 2 slots one on each face and on three sides are drilled holes 1.5″ deep. The diameter of the holes is determined by block thickness.

 

Material Thickness Block Dimensions
1″ or less 0.750″ x 6″ x 7″
Over 1″ through 2″ 1.50″ x 6″ x 10″
Over 2″ through 4″ 3.00″ x 6″ x 12″

You May Also Like