Select Page

Surface Profile Gauges

These gauges measure, and some record the peak to valley surface profile heights from Testex Press-0-Film replica tape.

Testex Micrometer Dial Thickness Gauge

The Testex Micrometer Dial Thickness Gauge is to be used with Testex replica Press-O-Film Tape to measure the surface roughness of blast cleaned surfaces.

Start measurements with the grade of tape with the target profile closest to the center of its range. Each grade of replica tape is most accurate near the center of its specified range.

Specifications

Grade: Range When Used With Gage
Medium: 5 to 75 microinch / 0.1 to 2 microns
Coarse: Minus: 0.5 to 1.0 mils / 12 to 25 microns
Coarse: 0.8 to 2.5 mils / 20 to 64 microns
X-Coarse: 1.5 to 4.5 mils / 38 to 115 microns
X-Coarse Plus: 4.6 to 5.0 mils / 116 to 147 microns

Defelsko RTRH-1 Positector RTR H1 Standard Replica Tape Reader

  • PosiTector Standard Gage Body BDYSTD
  • PosiTector RTR H Probe PRBRTRH
  • Stainless steel burnishing tool and 5 cleaning cards
  • Surface cleaning putty and check shim(s)
  • Protective lens shield with belt clip
  • Wrist strap and protective rubber holster with belt clip
  • 3 AAA alkaline batteries
  • PosiSoft Software and USB cable
  • Long Form Certificate of Calibration traceable to PTB
  • Nylon carrying case shoulder strap and instructions
  • Two (2) year warranty

Specifications

Peak Height (HL) Measurement Range 20 to 115 μm (0.8 to 4.5 mils)
Peak Height (HL) Accuracy ± 5 μm (± 0.2 mils)
Peak Height (HL) Resolution 1 μm (0.1 mil)
Anvil Diameter Ø6.35 mm (Ø0.25 inch)
Anvil Pressure 110 gram-force (1.1 Newtons)
Size 152 x 61 x 28 mm | (6″ x 2.4″ x 1.1″)
Weight 140 g (4.9 oz.) without batteries